Philips LPC2214 (ARM) Ethernet Board with LCD, USB, RS232, SD

Description

Philips LPC2214 (ARM) Ethernet Board with LCD, USB, RS232, SD
LPC-E2214
Hardware Rev. B
LPC2214 Ethernet Board Features
MCU: 16/32-bit NXP LPC2214 ARM7TDMI-S with 256 kBytes Program Flash, 16 kBytes RAM, External Memory Bus, RTC, 8x 10-bit ADC 2.44 µS, 2x UARTs, I2C, 2x SPI, 2x 32-bit Timers with 4 capture and 4 compare channels, 6x PWM, WDT, 5V tolerant I/O, up to 60 MHz operation
1MB (256K x 32 bit) 12 ns 71V416 SRAM
1MB (512K x 16 bit) 55 ns MX26LV800BTC Flash
Standard JTAG connector with ARM 2x10 layout for programming and debugging with
ARM-JTAG
Powered through USB port or via external 6V AC / 9V DC supply
USB-to-RS232 converter
Ethernet controller with Davicom DM9000E and RJ45 connector
SD/MMC slot (on bottom side; not pictured)
RESET circuit can be controlled externally by Philips ISP utility via USB-RS232 virtual port
Jumper setting to boot from external memory
Jumper setting for ISP/RUN mode selection
16x2 LCD with backlight
Two pushbuttons
Potentiometer connected to ADC
Universal extension connector (see below)
RS232 driver and connector
I2C 24LC515 EEPROM on board
Two on-board voltage regulators: 1.8V and 3.3V with up to 800mA current
Add-on UEXT Modules Available
This board has a universal extension connector, UEXT, which allows you to add a peripheral module easily. The UEXT can provide I2C, RS232, SPI and power to the external device. Please see the
UEXT Boards Category
for a full list of modules that can plug into the UEXT port.
LPC2214 Ethernet Board Resources
LPC2214/2294 Ethernet Board Documentation
(PDF file; 158kB)
Ethernet Board Schematic
(for the LPC-E2294, which is the same design but adds 4x CAN controllers and connectors)
Test software and basic routines
for access to external Flash/SRAM
OpenOCD + Eclipse set of projects 1.00
.