-40%
MSP430F413 Header Board, JTAG, 8kB Flash, 256B RAM & Data Flash
$ 4.22
- Description
- Size Guide
Description
MSP430F413 Header Board, JTAG, 8kB Flash, 256B RAM & Data FlashMSP430-H413
MSP430F413 Header Board Features
MSP430F413 MCU with 8 kBytes Program Flash, 256 Bytes data Flash, 256 Bytes RAM
MSP430-JTAG connector (top)
JTAG Power_In and Power_Out jumpers
32.768 kHz oscillator crystal
Socket for optional high-frequency crystal
TEST pin pull-down
RST/NMI pin pull-up
Power supply filtering capacitor
Extension headers for each uC pin
PCB: FR-4, 1.5 mm (0.062"), green soldermask, white silkscreen component print
Dimensions: 48 x 48 mm (1.9 x 1.9")
Space between the pin rows: 43.18 mm (1.7")
JTAG Power_In and Power_Out Jumpers
The
Power_In
jumper (P_IN) connects the power supply from the JTAG connector to the MSP430F413. When this jumper is placed, you can program the microcontroller on the board without any other external supply. Note that if the MSP430F413 board is plugged into another target board, you must ensure that this circuit doesn't draw more than a few milliamperes, due to the JTAG port current limitations. Power_In is useful to program your board when it is used standalone and not plugged into another target board.
The
Power_Out
jumper (P_OUT) connects power from the MSP430F413 board to the JTAG connector. When this jumper is placed, the power supply of the JTAG debugger/programmer will follow the power supply of the header board. This is useful when your board is plugged into an additional target board that draws a higher current or works at an operating voltage lower than +3.3V.
Note:
Never place both the P_IN and P_OUT jumpers at the same time. Always make sure only one jumper is closed.