LPC2294 (ARM7) Board, Ethernet, CAN, RS232, SD/MMC, 1MB SRAM

Description

LPC2294 (ARM7) Board, Ethernet, CAN, RS232, SD/MMC, 1MB SRAM
LPC-L2294
LPC2294 Development Board with 1MB SRAM, 4MB Flash, CAN, RS232, Ethernet, SD/MMC
LPC2294 Development Board Features
NXP LPC2294 16/32-bit ARM7TDMI-S MCU with 256 kBytes Program Flash, 16 kBytes RAM, External memory bus, RTC, 4x 10-bit ADC at 2.44 uS, 2x UARTs, 4x CAN, I2C, SPI, 2x 32-bit Timers, 7x CCR, 6x PWM, WDT, 5V tolerant I/O, up to 60 MHz operation
Standard
JTAG connector
with ARM 2x10-pin layout for programming/debugging (such as with
ARM-JTAG
)
1MB 70 ns SRAM
4MB (2Mx16bit) 70 ns TE28F320C3BD70 C3 Intel Flash
CS8900A Ethernet controller with RJ45 connector (16-bit mode with interrupt)
RS232 port
CAN drivers and connector
SD/MMC card connector
All LPC2294 port signals available on extension connectors
Reset button
Reset circuit can be controlled externally by NXP ISP utility via USB-RS232 virtual port
Jumper setting to boot from external memory
Jumper setting for ISP/RUN mode selection
User button
Two on-board voltage regulators: 1.8V and 3.3V with up to 800mA current
Dimensions: 118 x 101 mm ( 4.65 x 3.97")
This board is capable of running eCos with many applications, including TCP/IP.
Add-on UEXT Modules Available
This board has a universal extension connector, UEXT, which allows you to add a peripheral module easily. The UEXT can provide I2C, RS232, SPI and power to the external device. Please see the for a full list of modules that can plug into the UEXT port.
LPC2294 Development Board Resources
LPC-L2294 User Manual and Schematic
eCos port
instructions from Sergei Gavrikov who managed to port and run eCos on this board.
BLINK LED
project for GCC+OpenOCD+ECLIPSE
GCC+Eclipse+OpenOCD uIP complete project
OpenOCD + Eclipse set of projects 1.00
includes Flash write makefile for LPC-L2294.
UEXT Boards Category