LPC2294 (ARM7) Board, 4x CAN, 2x16 LCD, Ethernet, USB, RS232

Description

LPC2294 (ARM7) Board, 4x CAN, 2x16 LCD, Ethernet, USB, RS232
LPC-E2294
Hardware Rev. B
LPC2294 Ethernet Board Features
MCU: 16/32-bit NXP LPC2294 ARM7TDMI-S with 256 kBytes Program Flash, 16 kBytes RAM, External Memory Bus, RTC, 8x 10-bit ADC 2.44 µS, 2x UARTs, 4x CAN, I2C, 2x SPI, 2x 32-bit Timers with 4 capture and 4 compare channels, 6x PWM, WDT, 5V tolerant I/O, up to 60 MHz operation
1MB (256K x 32-bit) 12 ns 71V416 SRAM
2MB (512K x 16-bit) 70ns TE28F160C3 C3 Intel FLASH
Standard JTAG connector with ARM 2x10 layout for programming and debugging with
ARM-JTAG
Powered through USB port or external 6V AC / 9V DC supply
USB-to-RS232 converter
4 CAN drivers and connectors
Davicom DM9000E Ethernet controller and RJ45 connector
SD/MMC slot (on bottom side; not pictured)
RESET circuit can be controlled externally by NXP ISP utility via USB-RS232 virtual port
Jumper setting to boot from external memory
Jumper setting for ISP/RUN mode selection
16x2 LCD with backlight
Two pushbuttons
Potentiometer connected to AIN0
RS232 driver and connector
Universal extension connector (see below)
I2C 24LC515 EEPROM on board
Two on-board voltage regulators: 1.8V and 3.3V with up to 800mA current
Add-on UEXT Modules Available
This board has a universal extension connector, UEXT, which allows you to add a peripheral module easily. The UEXT can provide I2C, RS232, SPI and power to the external device. Please see the for a full list of modules that can plug into the UEXT port.
LPC2294 Ethernet Board Resources
OpenOCD + Eclipse set of projects 1.00
UEXT Boards Category
LPC2214/2294 Ethernet Board Documentation
(PDF file; 158kB)
LPC2294 Ethernet Board Schematic
Test software and basic routines
for access to external Flash/SRAM
.