-40%
Atmel ATtiny2313-20PU AVR Microcontroller, 20 DIP, 20 MHz
$ 0.79
- Description
- Size Guide
Description
Atmel ATtiny2313-20PU AVR Microcontroller, 20 DIP, 20 MHzATtiny2313-20P
Low-power CMOS 8-bit AVR microcontroller in 20-pin DIP package, Lead-free, RoHS compliant
By executing powerful instructions in a single clock cycle, the ATtiny2313 achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.
Note: The ATtiny2313-20PU is identical in function to the ATtiny2313-20PI. The only difference is that the -20PU comes in a lead-free RoHS-compliant package.
Features include 2 Kbytes of In-System Programmable Flash, 128 Bytes EEPROM, 128 Bytes SRAM, 18 general-purpose I/O lines, 32 general-purpose working registers, a single-wire Interface for On-chip Debugging, two flexible Timer/Counters with compare modes, internal and external interrupts, a serial programmable USART, Universal Serial Interface with Start Condition Detector, a programmable Watchdog Timer with internal Oscillator, and three software selectable power saving modes. The Idle mode stops the CPU while allowing the SRAM, Timer/Counters, and interrupt system to continue functioning. The Power-down mode saves the register contents but freezes the Oscillator, disabling all other chip functions until the next interrupt or hardware reset. In Standby mode, the crystal/resonator Oscillator is running while the rest of the device is sleeping. This allows very fast start-up combined with low-power consumption.
ATtiny2313 Microcontroller Features
AVR – High-performance and Low-power RISC Architecture
120 powerful instructions -- most single clock cycle execution
32 x 8 general-purpose working registers
Fully static operation
Up to 20 MIPS throughput at 20 MHz
Data and Non-volatile Program and Data Memories
2 Kbytes of in-system self programmable Flash (10,000 Write/Erase Cycles)
128 Bytes in-system programmable EEPROM (100,000 Write/Erase Cycles)
128 Bytes internal SRAM
Programming Lock for Flash Program and EEPROM Data security
Peripheral Features
One 8-bit Timer/Counter with separate Prescaler and Compare Mode
One 16-bit Timer/Counter with separate Prescaler, Compare and Capture Modes
Four PWM channels
On-chip Analog Comparator
Programmable Watchdog Timer with On-chip Oscillator
USI – Universal Serial Interface
Full-duplex USART
Special Microcontroller Features
debugWIRE on-chip debugging
In-System Programmable via SPI port
External and internal Interrupt sources
Low-power Idle, Power-down, and Standby modes
Enhanced Power-on Reset circuit
Programmable Brown-out Detection Circuit
Internal Calibrated Oscillator
18 Programmable I/O lines
Operating Voltage: 2.7-5.5V
Industrial temperature range (-40°C to 85°C)