-40%
Arduino Mega Prototyping Shield Kit
$ 2.61
- Description
- Size Guide
Description
Arduino Mega Prototyping Shield KitImportant Note on Shipping Delays via United States Postal Service: Currently we see significant delays in shipments via USPS, up to 3 weeks (!) to deliver within the USA. If you need your item fast, we suggest you select Fedex shipping upon checkout, instead of the standard USPS shipping.
DEV-09346
The MegaShield mates with an Arduino Mega board and gives you a prototyping area and two general LEDs. Also, the Arduino Mega reset switch is brought to the top level. The shield also works with two
mini solderless breadboards
if you don't want to solder to the prototyping area.
Note:
This comes in kit form and must be soldered together by the end user. All soldering is through-hole (relatively easy), but always check your component orientation before soldering. Most importantly, however,
the kit only comes with 8-pin stackable headers
. To complete the build with the parts provided, careful cutting of some of the stackable headers will be required. You can avoid having to cut connectors if you add a
6-pin
and two
10-pin
headers to your order.
Arduino MegaShield Kit Features
All Arduino Mega pins are brought to the top level
5V and GND power buses
Power LED
Status LED connected to D13
Reset Button brought to top level
Arduino MegaShield Kit Contents
MegaShield PCB with slightly staggered header pin holes to ensure headers stay in place during soldering
11 eight-pin stackable headers (some must be cut in order to create six-pin and 2x18-pin headers; it is recommended instead to purchase a 6-pin and two 10-pin headers from the options below)
Bright 5mm green LED
Bright 5mm red LED
Two 330 Ohm resistors
One 10k Ohm resistor
Momentary push button